二维码

中文网站

Tel:86-13113020858

E-mail: sales018@gangyuan.com.cn

Gangyuan

gangyuanelectronIc

LocationHome » News Center » FAQs » Use light touch switch has the need to pay attention to what?

Contact Us

  • sales018@gangyuan.com.cn
  • +86-755-83782228
  • +86-755-83647288
  • No.7 Building 1, Wuhe Rd, Longhua District, Shenzhen.
HOTLINE:+86-13113020858

Use light touch switch has the need to pay attention to what?

Large Middle Small Source:Gangyuan View:- Date:2016-11-07 19:34:00

Normally when we were in the use of touch switch what problems are easy to overlook, shenzhen light touch switch manufacturers are described further in this article we use light touch switch need to be aware of matters, the concrete content is as follows:

1. Set of welding condition, please according to the actual production conditions.

2. Because, when welding the water-soluble flux has the potential to make the switch corrosion, please avoid to use.

3. If used in more than rated voltage, there will be a poor contact may, for the above situation, please give confirmation.

Use light touch switch has the need to pay attention to what?

4. Please note that should according to each switch categories of beating and oscillation circuit set set (software) into composite components do not produce false action.

5. With carbon contact for push load characteristics of the contact resistance to change. Used for electric subsection pressure circuit and so on, please use after fully confirmed.

6. The product in the design and fabrication of the resistance of the dc load as the prerequisite. Use other load (inductance load (L), capacitive load (C)), please give confirmation.

7. Not clean. To shaft lever type, try to press the switch center department. For hinge structure, press the shaft rod press position will move, please pay special attention to.

Around

8. If you use the switch of the machine material produce corrosive gas, is likely to cause the phenomenon such as poor contact, so please be fully confirmed in advance.

9. To the terminal during welding, if applied load on the terminal, due to the different conditions will have loose, deformation and the possibility of electrical characteristics degradation, please pay attention to when using.

10. Note cannot be used in the temperature range near the near the upper limit and lower limit of continuous use for a long time. Please note shall, in accordance with the provisions of the conditions of use of the product specifications of the various environmental test range.

Gangyuan electronics specializing in the production of: light touch switch, toggle switch, button switch, patch light touch switch, patch toggle switch, high temperature resistant light touch switch, high temperature resistant, toggle switch, high quality light touch switch, touch switch factory, repeated ten million times, the quality is consistent. Email: yzc@gangyuan.com.cn